![]() ![]() Depending on your Linux distribution, it can be located in the menu items at the top, or at the bottom of your screen. In this example, your default gateway (router) IP address is 192.168.1.1.When Command Prompt is open, type the following command: ipconfig | findstr /i "Gateway" (You can copy & paste it in the command prompt just right-click anywhere in the command prompt window and select Paste.)Ĭ:\Documents and Settings\administrator>ipconfig | findstr /i "Gateway"ĭefault Gateway.Click Start > All Programs > Accessories > Command Prompt. ![]() It's what you type in your browser address bar to reach the configuration interface (example: ) and, if not, you can find it with the following steps: If you have ever had to access your router to configure it, you should know the address. If you need to change the guest-assigned IP range for some reason, please refer to Section 9.11, “Fine-tuning the VirtualBox NAT engine”.It's important for you to know the internal IP address of your default gateway, which is normally your router's LAN IP address. ![]() As more than one card of a virtual machine can be set up to use NAT, the first card is connected to the private network 10.0.2.0, the second card to the network 10.0.3.0 and so on. The IP address thus assigned to the virtual machine is usually on a completely different network than the host. The virtual machine receives its network address and configuration on the private network from a DHCP server integrated into VirtualBox. To your original Q, it is only VirtualBox that knows about the guest's simulated address: VirtualBox listens for replies to the packages sent, and repacks and resends them to the guest machine on its private network. To an application on the host, or to another computer on the same network as the host, it looks like the data was sent by the VirtualBox application on the host, using an IP address belonging to the host. The network frames sent out by the guest operating system are received by VirtualBox's NAT engine, which extracts the TCP/IP data and resends it using the host operating system. ![]() the IP chain' it's VirtualBox, not the host as such, that does this: FOR NAT MODE (per comments) from the manual subsection on NAT mode virtual networking ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |